Stainless Steel Homebrew Tower Kit: Dispense home brewed beers from your Pin-lock style or Ball-Lock style Cornelius Firestone Pepsi Coke Kegs.
Regulator: The new style commercial TapRite with auto pressure release incorporates the best features of the many other brands of regulators that we sell, but is offered at an affordable price. It has a new adjustment knob that allows pressure to be easily adjusted by hand (no tool required!). The shut-off valves are ball type check valves that prevent beer back-up into regulator. Regulator has a maximum pressure safety system (blow off at 55 to 60 PSI.) The permanent seal at the inlet nipple provides enhanced protection of leaks and the O-ring setup on the tank side eliminates the need for fiber washers upon refill. Heavy duty dual gauges. The two-way gas manifold has check-valves that will maintain pressure regardless of your CO2 tank pressure level and will not allow for bleed through from attached kegs at higher pressures.
This double gauge regulator has one gauge to assist you in supplying the correct amount of pressure through the lines and a second gauge to let you know when it is time to trade the Co2 tank in for a full one. Believe us – nothing spoils the party quicker than running out of Co2 after the CO2 gas stores have closed.
Quick Disconnect Keg Couplers: Both the Ball Lock and Pin Lock keg couplers feature ¼ inch MFL connections that allow for easy swapping of the beverage and gas side for force carbonation through the dip tube or exchanging for a quick connect Sanke. This feature offers increased kit flexibility, is not typically included in other kits, and is one feature that many beer brewers consider valuable.
Tower: The 3” Diameter Draft Tower is completely made of Stainless Steel and does not feature any plastic parts that are commonly found in lower quality towers. The chrome plated faucet has a brass lever and is connected to a 3’ length 3/16 ID hose with either “quick connect” ball-lock or fixed pin-lock connectors depending on the customer’s preference. Mounting screws, gasket, and black ABS handles are included. Additionally, the tower has foam insulation to reduce sweating and assist in maintaining cold beer lines. The manufacturer of this tower has gone the extra mile to completely seam weld the flange rather than the more typical spot-weld.
Material Stainless Steel
Hose Total of 3’ of clear 3/16 hose with hex coupling nuts
Dispensing System Insulated (1” Foam) , air-cooled, 1-Keg
Keg Connectors Quick disconnect ball-lock or fixed pin-lock keg type
Height 12 “
Diameter 3” Tower, 4.5” Flange
(OPTIONAL) 5 Lb Aluminum CO2 Cylinder: Brand new tank manufactured in 2009. This tank will not need to be hydrostatically tested for 5 years. All of our CO2 cylinders are produced from high strength aluminum alloy 6061-T6. This particular tank is popular because it is not as heavy as a comparably sized steel tank and will not rust because of its corrosion resistant interior and exterior. The service pressure is up to 1800 PSI/124 BAR with a test pressure of 3000 PSI/207 BAR. These cylinders have been independently tested over 100,000 cycles and are stamped with required U.S. Department of Transportation and Transport Canada Markings. The 320 Valves are CGA approved, and have a 1.125-12 UNF-2B male thread designed for use with CO2 Regulators. 2.5, 10, & 15 lb CO2 tanks are also available as an option.
Material Brushed Aluminum Cylinder/Brass Valve
Valve Threads CGA 320 with 1.125 Male Thread (Use with CO2 Regulator)
Weight (Empty) 7 lbs 8 oz
Capacity 5 Lbs (5 to 7 Kegs)
Height 18.25 “